Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 297: Tone Detection Verification Test (#42) 3 of 3
Error
Code
110-122
130
Test
Result
Description / Recommendation
FAIL A Tone Level Test failed.
Forward/backward MFC signals not correctly generated/detected.
1. Run the short test sequence with test port location
2. If the problem persists, the system is still operating properly but
capacity will be reduced. To restore performance to normal,
replace the circuit pack containing the defective port. See
TONE-BD (Tone-Clock Circuit Pack) for the procedures to
replace a Tone-Clock circuit pack.
1022 FAIL Invalid tone detector circuit pack. Tone detection for the system is
administered as wideband but the tone detector circuit pack is invalid.
Ports on invalid types of tone detector circuit packs are taken out of
service since they cot provide the administered function.
1. Change the tone-detection mode administered on the
system-parameters country-options screen, or remove every
tone detector circuit pack from the system except the following:
TN2182, TN2312, TN8412, TN420C or later, TN744C or later.
2. Retry the command.
PASS Tone detection verification is successful. The port is able to detect and
generate every necessary tone.
Tone Detector Audit/Update Test (#43)
The Tone Detector Audit/Update Test performs a sanity audit on the following port types:
● CLSFY-PT (Call Classifier Port)
● DTMR-PT (Dual-Tone Multifrequency Receiver Port)
● ETR-PT (Enhanced Tone Receiver Port)
● GPTD-PT (General-Purpose Tone Detector Port)
● TONE-BD (Tone-Clock Circuit Pack)
1142 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 3