Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 340: Yellow Alarm Inquiry Test (#141) 2 of 2
Error
Code
Test
Result
2000 ABORT Response to the test was not received within the allowed time. This may
be due to hyperactivity.
1. Enter display errors on the SAT.
2. Check for Error Type 1538 for this DS1 board. If Error Type 1538
appears in the error log for this board, see Hyperactive DS1/UDS1
Interface Circuit Pack/Media Module for the repair procedures.
Otherwise, retry the test at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The DS1/UDS1 interface circuit pack or media module detected a yellow
alarm sent by the remote DS1 endpoint. An out of frame condition
occurred at the DS1 endpoint.
1 FAIL The DS1/UDS1 Interface circuit pack or media module detected a
Remote Multiframe Alarm sent by the remote DS1 endpoint. An
out-of-frame condition occurs on the remote DS1 endpoint.
2 FAIL The DS1/UDS1 Interface circuit pack or media module is reporting a
yellow F5 State alarm. There is a fault in the user-network interface from
the user to the network.
1. If the DS1/UDS1 circuit pack or media module connects to a T1
network facility or to another switch, see T1 Network Facility
Procedures
0 NO
BOARD
Description / Recommendation
2. If the DS1/UDS1 circuit pack or media module connects to a
line-side terminating device such as a PRI terminal adapter, see
Line-side Terminating Device Procedures
PASS No Yellow alarm or Remote Multiframe Alarm or F5 State Alarm is
received from the remote DS1 endpoint.
See NO BOARD for the repair procedures.
1250 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2