Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Analog Line Ringer Update Test (#62)
A ‘‘ringer on’’ or a ‘‘ringer off’’ message is sent to the firmware to start and stop the ringer on the
set. This test runs on HYB-LINE (Hybrid Line) and MET-LINE (MET Line).
Table 312: Analog Line Ringer Update Test (#62) 1 of 2
Error
Code
Test
Result
Description / Recommendation
3 ABORT This port may have been busied out by system technician.
1. Look in the Error Log for Error Type 18 (port busied out) for this
port. If this Error Type is present, release the port with the
release station extension command, and run the test
again.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
1000
1004
ABORT System resources required to run this test are not available.
The port was seized by a valid call during the test.
1. Enter display port location to determine the station
extension number of the port.
2. Enter status station to determine the service state of the
port. If the port is in use, wait until it is idle before testing.
3. Retry the command at 1-minute intervals up to 5 times.
1392 ABORT This port is a TTI port. The test does not run on TTI ports.
1. Verify that the port is a TTI port using either display port,
(the port is a TTI port) or list config, which shows a t for the
port.
2. If either list config or display port indicate that the port
is not a TTI port, escalate the problem. If both commands
indicate that the port is a TTI port, the abort is correct, and no
action is necessary.
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1174 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2