Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Speech Synthesis DTMF Sanity Inquiry (#164)
This test determines the sanity of the port’s dual-tone multifrequency (DTMF) receiver. The
on-board microprocessor tests the port’s DTMF receiver and determines if it is in a sane (test
passes) or insane (test fails) condition. This test runs on S-SYN-PT (Speech Synthesis Port).
Table 352: Speech Synthesis DTMF Sanity Inquiry (#164)
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port
may be busy with a valid call. Wait until the port is idle (amber LED is off)
before retesting.
1. Retry the command at 1-minute intervals up to 5 times.
2000
2100
ABORT Response to the test request was not received within the allowed time.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The DTMF receiver for this port is insane.
1. If the test fails again, replace the circuit pack.
PASS The DTMF receiver for this port is sane. User-reported troubles should be
investigated using other tests and by verifying other ports on this circuit
pack are working correctly.
Speech Synthesis DSP Tone Test (#165)
The digital signal processor (DSP) associated with each port can generate a 440-Hz tone which
can be detected by TN748 General-Purpose Tone Detector circuits. A 440-Hz tone is generated
for 500 ms on a specified time slot which is being listened to by the detector circuit. If the
detector determines the tone is present on the time slot, the test passes. Otherwise, it fails.
This test runs on S-SYN-PT (Speech Synthesis Port).
1270 Maintenance Alarms for Communication Manager, Media Gateways and Servers