Demand test descriptions and error codes - Avaya Support

TONE-PT (Tone Generator)
TONE-PT (Tone Generator)
MO Name in Log Alarm Level Initial Command to Run Full Name of MO
TONE-PT MAJ
MIN
Note:
Note: Replacing the IPSI or Tone-Clock circuit pack requires a special procedure which
is described in TONE-BD (Tone-Clock Circuit Pack). That section also describes
the LED display for this board.
The tone generator resides on the IPSI or Tone-Clock circuit pack and provides all system tones
such as dial tone, busy tone, and so on. If an active tone generator fails, its port network may
not have tones (see Tone Generator Transmission Test (#40). For instance, a user may go
off-hook and hear no dial tone. This problem will affect only users on the same port network
where the faulty IPSI or Tone-Clock circuit pack resides. The system will be able to process
certain type of calls (that is, internal calls will succeed while outgoing calls will not).
The IPSI or Tone-Clock circuit pack also provides the clocks for the system and can serve as
the synchronization reference. Therefore, when resolving alarms, use the TDM-CLK (TDM Bus
Clock), SYNC (Port Network Synchronization), and TONE-BD (Tone-Clock Circuit Pack) repair
procedures.
See TONE-BD (Tone-Clock Circuit Pack) for a discussion of the relationship of Tone-Clock
circuit packs with the various reliability options.
Error log entries and recommended actions
test tone-clock location Tone Generator
WRN release tone-clock location
Table 270: TONE-PT Error Log Entries 1 of 2
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
Recommended
Action
0 (a) 0 Any Any Any test tone-clock
location 1
1 (b) 17664 Tone Generator Audit/
Update (#41)
MAJ
MIN 2
ON test tone-clock
location r 2
18 (c) 0 busyout tone-clock location WRN OFF release
tone-clock
location
1 of 2
Issue 5 May 2009 1011