Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 511: RC NPE Port Audit Test (#1315) 2 of 2
Error
Code
Test
Result
1-24 FAIL The Error Code identifies the NPE for which the RC NPE Port
Crosstalk test failed.
1. Enter test board loc long repeat 24
2. If any of the tests fail, replace the RC circuit pack.
ANY NO
BOARD
Description / Recommendation
RC NPE Port Loop Test (#1316)
UTAM disablement of radio transmission usually causes this problem.
1. Check the Radio Transmission option. This option can be
changed only at the INADS or higher level.
2. Verify the system is not booting.
3. Enter display radio-controller loc and verify that the
RC is administered.
4. Retry the command at 1-minute intervals up to 5 times.
5. If the test continues to abort, escalate the problem.
PASS All of the NPEs are functioning normally.
The circuit pack must be busied out before running this test.
This tests executes the NPE Digital Port Loop Test on a Radio controller (RC) NPE port. If the
test is unsuccessful, the port number (1-24) of the RC NPE port which failed is returned.
1638 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2