Demand test descriptions and error codes - Avaya Support

Table 429: Signaling Link Board Check (#643)
Error
Code
Test
Result
Description / Recommendation
Layer 2 Status Query Test (#647)
Layer 2 Status Query Test (#647)
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1700 ABORT Rollabout video abort. The PRI terminal adapter associated with this
D-chel port is detached from the circuit pack. This is normal when the
rollabout video feature is enabled. To complete a test on this port:
1. Re-attach the disconnected PRI terminal adapter.
2. Enter change ds1 location to disable rollabout video on the
board, and set the “Alarm when PRI Endpoint Detached” field to y.
8 FAIL The circuit pack is not in service.
1. Check the Hardware Error Log for entries logged against
UDS1-BD or ATM-TRK. Consult UDS1-BD (UDS1 Interface Circuit
Pack) or ATM-TRK (Circuit Emulation Service Circuit Pack) for
repair procedures.
Any NO
BOARD
PASS The circuit pack or media module transporting the ISDN-PRI Signaling
Link Port is in service.
See NO BOARD for the repair procedures.
The Layer 2 Status Query Test checks the Layer 2 status of the ATM-SGRP or ISDN-PRI
Signaling Chel (D-chel). This test will fail if there is a hardware failure or a facility problem, or if
the primary and secondary ISDN-PRI D-chels are not administered correctly.
The Primary and Secondary Signaling Link Hardware Tests (Tests #636 and #639), the ATM
Remote Layer 3 Query Test (test #1291), and the Remote Layer 3 Query Test (#637) will detect
most problems caused by hardware failures or incorrect administration.
This test runs on ATM-SGRP (ATM Signaling Group) and ISDN-SGR (ISDN-PRI Signaling
Group).
Issue 5 May 2009 1433