Demand test descriptions and error codes - Avaya Support

MEDPROPT (MEDPRO DSP PORT)
MO Name in Log Alarm Level Initial Command to Run Full Name of MO
MEDPROPT MIN
WRN
test port location TN802/TN2302/TN2602
MEDPRO DSP PORT
The Media Processor Port (MEDPROPT) MO monitors the health of the Media Processor
(MEDPRO) digital signal processors (DSPs). This maintenance object resides on the TN802/
TN2302/TN2602 Media Processor circuit packs.
The TN802B MAP-D (Multi-Application Platform for DEFINITY) Media Processor circuit pack,
the TN2302, and TN2602 Media Processor circuit packs provide the audio bearer channels for
H.323 voice over IP calls.
● One TN802B circuit pack has one MEDPROPT media processing resource; that one
TN802B MEDPROPT can handle 31 channels, for a total of 31 channels per TN802B.
Note that the TN802B has 11 physical DSP devices but they are treated as one logical
MEDPROPT by Communication Manager software. If the list ip-codec-set screen
specifies only G.711 mu-law or G.711 a-law as the audio codecs, the TN802B MEDPROPT
can service 31 channels. If any other codec type (G.723-5.3K, G.723-6.3K, or G.729) is
administered, the TN802B MEDPROPT can service 22 channels.
● One TN2302AP has 8 MEDPROPTs. Each TN2302 MEDPROPT has the processing
capacity to handle 8 G.711 coded channels, for a total of 64 channels per TN2302. Note
that early TN2302AP boards have eight physical DSP devices. Vintage 11 and later
TN2302AP boards have two physical DSP devices. Both board configurations provide
eight MEDPROPTs and a total of 64 channels.
When only G.711 codecs are in use the TN2302AP has the processing capacity to handle
64 channels. If only G.723/G.729 codecs are in use the TN2302AP has the processing
capacity to support 32 channels. If a combination of G.711 and G.723/G.729 codecs are in
use the number of channels supported will fall somewhere between 32 and 64. Use the
list ip-codec-set command to display the administered codecs.
● The capacity provided by the TN2602 is controlled by the Communication Manager license
file and may be set at either 80 G.711 channels or 320 G.711 channels. Depending on the
codecs used by individual calls the number of simultaneous calls supported will vary. The
TN2602 supports G.711, G.729A, G.729AB, and G.726 codecs.
If individual DSPs on the TN802B or TN2302AP or TN2602 fail, the board remains in-service at
lower capacity.
The MEDPROPT is a shared service circuit. It is shared between H.323 trunk channels and
H.323 stations. An idle channel is allocated to an H.323 trunk/station on a call-by-call basis.
616 Maintenance Alarms for Communication Manager, Media Gateways and Servers