Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 409: Congestion Query Test (#600) 2 of 2
Error
Code
1
2
Test
Result
Description / Recommendation
FAIL The buffer level is nearly exhausted.
The circuit pack is congested and no buffers are available.
1. Retry command at 1-minute intervals up to 5 times.
2. If command continues to fail, examine the C-LAN or VAL port
measurements to determine which ports are heavily utilized and
the processor occupancy of the circuit pack.
Low processor occupancy when the circuit pack is congested indicates
circuit pack failure.
1. If the problem persists, reset the circuit pack with
reset board location.
2. If congestion recurs, replace the circuit pack.
High processor occupancy indicates the circuit pack is congested due to
traffic load.
1. To relieve congestion in the short term, selectively busyout ports
with busyout port location on the circuit pack.
2. To achieve a more permanent resolution for CLAN-BD circuit
packs, it may be necessary to move ports on this circuit pack to
other Control LAN circuit packs. For VAL-BD circuit packs, it may
be necessary to reassign announcements to other integrated
announcements circuit packs.
3. Consider replacing affected ports with new ports.
3 FAIL The circuit pack is not operating normally and is congested.
1. Replace the circuit pack.
PASS Hardware setting and attached cable type match circuit pack
administration, and no errors are detected.
1390 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2