Demand test descriptions and error codes - Avaya Support

Table 422: BRI Remote Loopback Test (#627) 2 of 4
Error
Code
Test
Result
Description / Recommendation
BRI Remote Loopback Test (#627)
1139 ABORT The PN’s packet bus is out-of-service.
1. Follow the repair procedures for the packet bus.
2. After completing step 1, enter test port long location, and
review the results of the BRI Port Local LAN Looparound Test
(#618) to verify the repair.
1144 ABRT The PPN’s packet bus is out-of-service.
1. Follow the repair procedures for the PPN’s packet bus.
2. After completing step 1, execute test port long PCSSpp, and
review the results of the BRI Port Local LAN Loop Around test
(#618) to verify the repair.
1187 ABORT The circuit pack, port, or station may have been busied out by a
technician.
1. Look in the Error Log for Error Type 18 (busied out) for BRI-BD,
BRI-PORT, or BRI-SET.
a. If this Error Type is present for BRI-SET only, then release the
station via the release station
b. If this Error Type is present for BRI-PORT and BRI-SET, then
release the port with release port location and run the
test again.
c. If the error is present for BRI-BD, BRI-PORT, and BRI-SET, then
release the circuit pack with release port location and
run the test again.
d. If the error is present for both BRI-BD and BRI-PORT, release
the circuit pack with release board location and run the
test again.
e. If the error is present for BRI-SET only, release the circuit pack
with release port location and run the test again.
Note: When
Note:
you release the circuit pack, you release every port
associated with it. If certain ports still need to be busied
out, enter busyout port location to busy them out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
2 of 4
Issue 5 May 2009 1415