Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 310: Analog Line Station Lamp Update Test (#60) 2 of 2
Error
Code
Test
Result
0 NO
BOARD
Description / Recommendation
Analog Line Audits Test (#61)
See NO BOARD for the recommended repair procedures.
This test is a series of three audits. These audits will abort if attempted on an out-of-service
station. The tests are as follows:
● Switchhook Audit: This updates the server’s records according to the circuit packs’
records.
● Bad Scan Inquiry: An uplink message is sent containing a count generated due to certain
events relating to the data link’s conditions. This indicates data-transmission problems
between the circuit pack and the voice terminal.
● EPF Inquiry: An uplink status message of the Electronic Power Feed is sent.
This test is run on HYB-LINE (Hybrid Line) and MET-LINE (MET Line).
Table 311: Analog Line Audits Test (#61) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1 ABORT Internal system error during the switchhook audit.
1. Make sure the station is not in an out-of-service state.
2. Retry the command at 1-minute intervals up to 5 times.
2 ABORT Internal system error during the bad scan audit.
1. Make sure the station is not in an out-of-service state.
2. Retry the command at 1-minute intervals up to 5 times.
1172 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2
1 of 2