Demand test descriptions and error codes - Avaya Support

Table 311: Analog Line Audits Test (#61) 2 of 2
Error
Code
Analog Line Audits Test (#61)
3 ABORT Internal system error occurred during the EPF inquiry audit.
1. Make sure the station is not in an out-of-service state.
2. Retry the command at 1-minute intervals up to 5 times.
1000
1004
Test
Result
ABORT System resources required to run this test are not available.
The port may be busy with a valid call.
1. Enter display port location to determine the station
extension number of the port.
2. Enter status station to determine the service state of the port. If
the port is in use, wait until it is idle before testing.
3. Retry the command at 1-minute intervals up to 5 times.
1392 ABORT This port is a TTI port. The test does not run on TTI ports.
1. Verify that the port is a TTI port using either display port (the
port is a TTI port) or list config (shows a t for the port).
2. If either list config or display port indicate that the port is
not a TTI port, escalate the problem. If both commands indicate that
the port is a TTI port, the abort is correct, and no action is
necessary.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS The Analog Line Audits test passed.
1. Although this test never actually returns a FAIL result except for an
Internal system error, it can enter Error Types 257 and 513 into the
Error Log. To check for problems that don’t show up in the test
result, look for these Error Types in the Error Log.
2. If these errors appear in the Error Log, or if user complaints still
exist, investigate by using other circuit pack tests and by examining
the station, wiring, and connections.
0 NO
BOARD
Description / Recommendation
See NO BOARD for the repair procedures.
2 of 2
Issue 5 May 2009 1173