Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Stratum-3 Clock Alarm Query (#649)
The Stratum-3 Clock Alarm Query Test queries the Stratum-3 clock for its alarm status and
reports the results of the query. The Stratum-3 clock provides the system with the following six
alarm indications via the TN780 Tone-Clock circuit pack:
● Reference A failed or CI card A failed.
● Reference B failed or CI card B failed.
● One power supply failed.
● Every power supply failed.
● One clock unit failed.
● Every clock unit failed.
! CAUTION:
CAUTION: The removal of a card in the Stratum-3 clock may cause alarm(s) to be resolved
and the query test to pass. However, the removed cards should still be replaced
to restore the Stratum-3 clock to full service.
This test runs on STRAT-3 (Stratum-3 Clock) and SYNC (Port Network Synchronization).
Table 431: Stratum-3 Clock Alarm Query Test (#649) 1 of 5
Error
Code
Test
Result
Description / Recommendation
1000 ABORT The system could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to up to 3 times.
1005 ABORT This test aborts when it is run on a Stratum-4 system. Do not change
synchronization to Stratum 3 without consulting the synchronization plan
administrator for this switch.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1436 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 5