Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 293: Port Diagnostic Test (#35) 6 of 6
Error
Code
Test
Result
0 NO
BOARD
PASS ALARM-PT: The port’s battery feed chip is able to provide power to the
external device alarm to detect contact closure.
ANL-16-L, ANL-LINE, AN-LN-PT, RANL-STA: The port’s battery feed
chip is able to provide power to the station equipment to detect on-/
off-hook but may not be able to supply power for touch-tones.
1. If touch-tones are not heard when buttons are pressed, replace
the circuit pack or media module.
2. Investigate user-reported troubles on this port by using other port
tests, by examining station wiring, or by examining the station.
DID-TRK: Current flow was detected for this port.
1. Investigate user-reported troubles on this port by using other port
tests and by examining connections to the port.
2. If problems continue, refer the problem to the CO.
MET-LINE: Current flow was properly detected for this port.
1. Investigate user-reported troubles on this port by using other port
tests and by examining connections to the port.
Port Audit And Update Test (#36)
The Port Audit and Update Test sends port level translation data from the switch processor to
the circuit pack to verify that the port’s translation and current state are correct.
When the ringer is in the off state, this test also turns off the station’s ringer to prevent constant
ringing caused by defective hardware.
For an analog line port which is administered as an external alarm, this test is limited to
updating the software with the switchhook state.
This test runs on the following maintenance objects:
● ADX16A-P (AUDIX Analog Line/Control Link)
● ALARM-PT (Alarm Port)
Description / Recommendation
See NO BOARD for the repair procedures.
1130 Maintenance Alarms for Communication Manager, Media Gateways and Servers
6 of 6