Demand test descriptions and error codes - Avaya Support

ADX16D-P (16-Port AUDIX Digital Port)
CAUTION: Never
MO Name in Log Alarm
Level
ADX16D-P MIN
WRN
ADX16D-P (16-Port AUDIX Digital Port)
! CAUTION:
do any of the following without first shutting down AUDIX. Follow the
instructions on the TN566/TN2169 faceplate:
● Remove EMBEDDED AUDIX circuit packs
Initial Command to Run Full Name of MO
test port location l AUDIX Digital port
● Cycle power to a carrier containing EMBEDDED AUDIX circuit packs
● Remove power to a carrier or cabinet containing EMBEDDED AUDIX circuit pack
The ADX16D-P MO represents a port on a TN566/TN2169 EMBEDDED AUDIX circuit pack
operating in digital-port (DP) mode. The maintenance strategy for ports on the TN566 operating
in control-link mode is described in ADX16A-P (AUDIX Analog Line/Control Link).
The tests apply only to switch-side maintenance that tests a circuit pack’s components related
to the TDM-bus interface. The AUDIX system has an extensive maintenance strategy that is
described in DEFINITY® AUDIX Maintenance, 585-300-110.
AUDIX resides on a combined pair of circuit packs: the TN566 Multifunction board (MFB) and
the TN2169 Alarm board (ALB). The 2 boards occupy 5 slots, but the system sees only 1 slot as
functional. The other 4 slots are seen by the switch as “AUDIX-reserved” slots (or ADX16-RES/
ADX16D-RS).
In 16-port DP mode, the TN566 pack supports up to 16 voice ports, each with a primary and a
secondary information chel. Ports are administered in increments of two. When a call to a
station with an AUDIX login is not answered, AUDIX answers the call using one of the available
voice ports.
Unlike other AUDIX systems, EMBEDDED AUDIX is not an adjunct.
Issue 5 May 2009 63