Demand test descriptions and error codes - Avaya Support

Table 418: CRC Error Counter Test (#623)
Error
Code
Test
Result
Description / Recommendation
Layer 1 Transmission Error Counter Test (#624)
2000 ABORT Response was not received from the circuit pack within the allowed time.
1. If the test aborts repeatedly up to 5 times, reset the circuit pack and
rerun the test.
2. If the test aborts again, replace the circuit pack.
2012
2100
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The circuit pack is detecting CRC errors. The Error Code field contains
the value of the counter. This error occurs when a frame with a bad CRC
is received over the D-Chel by the circuit pack.
The problem is most likely due to a problem with the wiring to the set or
adjunct, interference on the wiring caused by a noise source such as an
electrical motor or generator, or no termination (open circuit). It usually
does not indicate a problem with the circuit pack.
PASS The error counter was cleared successfully.
Layer 1 Transmission Error Counter Test (#624)
This test reads and clears the port’s Layer 1 Transmission error counter maintained on the ASAI
or BRI-LINE circuit pack. This counter is incremented by the circuit pack when it detects a Layer
1 transmission problem. The test passes if the value of the counter is 0 (that is, the error is
cleared). If the counter is not zero, the test fails, and the value of the counter is displayed in the
Error Code field.
This error is most likely due to a problem with the wiring or the endpoint or adjunct. Verify that
the wiring meets the configuration rules defined in DEFINITY® Communications System
Generic 1 and Generic 3i Wiring, 555-204-111. It does not indicate a problem with the circuit
pack. This test is useful for verifying the repair of the problem.
This test runs on ASAI-PT (ASAI Port) and BRI-PORT (ISDN-BRI Port).
Issue 5 May 2009 1409