Demand test descriptions and error codes - Avaya Support

Hybrid Line Remote Digital Looparound Test (#59)
Hybrid Line Remote Digital Looparound Test (#59)
This test checks the digital control pair from the port circuit to the terminal. The on-board
microprocessor sends a message to the terminal and checks for a proper return message. This
test is repeated three times, with two out of the three attempts passing being sufficient for this
test to pass. This test will run if the station is in service or out of service.
This test is run on HYB-LINE (Hybrid Line).
Table 309: Hybrid Line Remote Digital Looparound Test (#59) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1 ABORT A request for a remote station audit aborted even though all internal
resources were correctly allocated.
1. Look in the error log for Error Type 18 (port busied out) for this port.
If this Error Type is present, release the port with release port
location or release station extension, and then run the
test again.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port
may be busy with a valid call.
1. Enter display port location to determine the station
extension number of the port.
2. Enter status station to determine the service state of the port.
If the port is in use, wait until it is idle before testing.
3. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
1 of 2
Issue 5 May 2009 1169