Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 369: Neon Test (#220) 2 of 3
Error
Code
Test
Result
Description / Recommendation
1018 ABORT There are no translated ports on the circuit pack. If ports are translated,
none are administered to have "neon."
1. Verify there are ports administered on the circuit pack. If no ports
are administered, no further action is required.
2. Verify that neon sets are connected. If there are no neon sets
connected to the circuit pack, at least one port needs to be
translated with neon. To check if a port is translated with neon, use
display port location to determine the station extension of
any station on this circuit pack. Enter display station
extension to determine if the port is administered with neon. The
field "Message Waiting Indicator:" must be set to "neon" for at least
one of the administered ports. If this field is not administered to
"neon", the test continues to abort. This is acceptable because not
all stations have neon lamps on their analog terminals. If none of
the terminals have neon lamps, the test continues to abort, and no
further action is required.
3. Retry the command at 1-minute intervals a maximum of 5 times.
4. If the test continues to abort, look for RING-GEN (Analog Ring
Generator) errors in the Error Log. If an ABORT 1008 occurs for
this test on other circuit packs as well, then the ringing generator
may be defective. If ABORT 1008 does not occur on Test #48 for
ANL-16-L, all four ring phases are in use.
5. Retry the command again.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
2000 ABORT Response to the test was not received within the allowed time.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1302 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 3