Demand test descriptions and error codes - Avaya Support

CONFIG (System Configuration)
MO Name in Log Alarm Level Initial Command to Run Full Name of MO
CONFIG none none System Configuration
The System Configuration MO oversees logical insertion and removal of circuit packs in the
system. When the system detects that a circuit pack is present in a port slot, it queries the circuit
pack to determine the type and vintage of the circuit pack. The system also detects when a
circuit pack has been removed from a port slot.
There are no alarms or tests for System Configuration, but three types of errors are logged to
the error log.
Error log entries and recommended actions
Table 77: CONFIG Error Log Entries
Error Type Aux Data Associated
Test
0 (a) 0
1–119 (b) 0–63
Alarm
Level
257 (c) MAJ
1001–1119 (d) 0–63
On/Off
Board
Notes:
a. Error Type 0:An attempt was made by the system to raise an alarm against CONFIG
without first logging a CONFIG error.
b. Error Types 1-119: a port circuit pack in the system did not respond to a circuit pack type
inquiry. Follow the procedures outlined in (d) to determine whether there is an error.
c. Error Type 257: less than 25% of a trunk group is available.
d. Error Types 1001 - 1119: a port circuit pack in the system did not respond to a vintage
inquiry. A port circuit pack may be physically inserted in a port slot, but the system may not
recognize its existence. The Aux Data value specifies the circuit pack’s internal port
network number. To convert the Aux Data value to the physical port network number, add
290 Maintenance Alarms for Communication Manager, Media Gateways and Servers
Recommended
Action