Demand test descriptions and error codes - Avaya Support

e. Error Type 1025: Due to high traffic, the media gateway socket control process turned off
board and port periodic maintenance. When traffic levels decline, periodic maintenance will
be turned on again and the alarm resolved.
f. Error Type 1281: This error indicates that there has been a repetitive sequence of
unregistration and subsequent re-registration of a media gateway from a call server. The
call server may be a primary server, an LSP, or an ESS. This error and alarm can only be
generated if Enable Detection and Alarms for Hyperactive Media Gateway Registration
has been enabled on the system-parameters ip-options form. This alarm is most likely
caused by an IP network problem which causes the gateway to unregister and re-register
multiple times to a server within an interval that is less than the link bounce time. If an LSP
is present, and if the interval is greater than the link bounce time, the media gateway and
affected IP phones would most likely fail over to the LSP, and this MED-GTWY alarm would
not be generated. The disable/enable nr-registration network-region
commands can be used to deny registration of media gateways and IP phones from a
server in order to cause the media gateways and IP phones to search for an alternate
server. The alarm is resolved if there is no activity for 15 minutes. See NR-REG (Network
Region Registrations).
Demand test descriptions and error codes
Order of Investigation Short Test
Sequence
620 Maintenance Alarms for Communication Manager, Media Gateways and Servers
Long Test
Sequence
Link State Audit Test (#1527) X X ND
1. D = Destructive; ND = Nondestructive
D/ND 1
Media Gateway Hyperactivity Audit Test (#1659) X X ND