Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 527: Signaling Group Ping Test (#1387) 3 of 3
Error
Code
2802 ABORT Different IP address pinged than software had allocated for the test.
1. Retry the command at 1-minute intervals up to 3 times.
7
89
1007
Test
Result
Description / Recommendation
FAIL PING to the destination failed through this port because the destination
was down.
1. Verify that at least one destination reachable through this port is
“up”. Once verified, enter test signaling-group grp# to verify
that the Signaling Group Ping test (#1387) passes.
Any PASS PING through this port was successful.
MedPro Status Test (#1392)
This test determines if at least one media processor port is in service and serves the same
region as the C-LAN that the signaling group uses. If at least port one exists and is in service,
the test passes. Otherwise, the test fails.
This test runs on H323-SGR (H.323 Signaling Group) and SIP-SGRP (SIP Signaling Group).
Table 528: MedPro Status Test (#1392) 1 of 2
Error
Code
None
2012
2100
Test
Result
Description / Recommendation
ABORT Internal system error.
Internal system error.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times
2808 ABORT This test is not applicable when the SBS field on the H.323 signaling
group form is set to y.
1662 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 3
1 of 2