Demand test descriptions and error codes - Avaya Support

ATM Crosstalk Test (#1298)
ATM Crosstalk Test (#1298)
The ATM Crosstalk Test verifies that TDM time slots are correctly allocated to connections. It is
useful for diagnosing one-way or noisy connections. The test fails if the TDM programmable
logic and/or the interface to the DSP is not operating properly.
This test runs on ATM-EI (Expansion Interface Circuit Pack) and ATM-TRK (Circuit Emulation
Service Circuit Pack).
Note: This
Note:
test takes approximately 12 minutes and applies only to TN2305 and
TN2306 circuit packs.
Table 510: ATM Crosstalk Test (#1298) 1 of 3
Error
Code
Test
Result
Description / Recommendation
1002 ABORT The system could not allocate time slots for the test. The system may
be under heavy traffic conditions, or it may have time slots
out-of-service due to TDM-BUS errors. A system is considered under
heavy traffic when the Call Processing Occupancy is greater than
50% or when the System Management and the Call Processing
Occupancies together exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see
information regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1 of 3
Issue 5 May 2009 1635