Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 335: Internal Looparound Test (#135) 2 of 3
Error
Code
Test
Result
Description / Recommendation
1015 ABORT Ports on DS1 Interface circuit pack have not been busied out.
1. Enter busyout board location to put every trunk on the DS1
circuit pack into the out-of-service state.
2. Retry reset board location.
1039 ABORT The DS1 or UDS1 Interface circuit pack is providing timing for the system.
Therefore, it cot be reset without major system disruption.
1. If the DS1 or UDS1 Interface circuit pack needs to be reset, set the
synchronization reference to another DS1 or UDS1 Interface circuit
pack or to the IPSI or Tone-Clock circuit pack using the following
command sequence:
a. disable synchronization-switch
b. set synchronization location
c. enable synchronization-switch
1412 ABORT This test does not run on media modules or media gateways. Ignore.
2000 ABORT Response to the test was not received within the allowed time.
1. Enter display errors on the SAT.
2. Check for Error Type 1538 for this DS1 board. If Error Type 1538
appears in the error log for this board, see Hyperactive DS1/UDS1
Interface Circuit Pack/Media Module for the repair procedures.
Otherwise, retry the test at 1-minute intervals up to 5 times.
2012 ABORT Internal system error
1. Retry reset board location at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry reset board location at 1-minute intervals up to 5 times.
1232 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 3