Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
This test runs on DIG-IP-S (Digital IP Station) and H323-STN (H.323 IP Station).
..
Table 519: Signaling Path PING Test (#1373)
Error
Code
Test
Result
Description / Recommendation
ABORT This test does not run on media modules or media gateways. Ignore.
1427 ABORT This test does not apply to OPTIM stations. This error can be ignored.
2100 ABORT Could not locate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
1003 FAIL Ping to the destination failed.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Investigate any C-LAN Ethernet port errors.
1007 FAIL The system could not PING the registered endpoint via the C-LAN.
1. Verify that at least one destination reachable through this port. PING
this destination (ping ip-address xxx.xxx.xxx.xxx).
2. If the PING to any destination is successful through this port, the link
is up.
3. If the PING to every destination fails, test the C-LAN port using test
port location, and follow the repair procedures for Session
Status Test (#1286) failures.
4. If only this station cot be pinged:
● Make sure the PC is up.
● Make sure the PC has a network connection (Ethernet or dial-up).
● Check the Ethernet cabling.
PASS The system can successfully send IP packets to the registered endpoint
from the C-LAN.
1650 Maintenance Alarms for Communication Manager, Media Gateways and Servers