Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 398: Hook State Inquiry Test (#566) 2 of 2
Error
Code
Test
Result
Description / Recommendation
Any FAIL Internal system error. This test should never fail.
1. Retry the command at 1-minute intervals up to 3 times.
2. If the test continues to fail, reset the circuit pack.
3. Retry the command at 1-minute intervals up to 3 times.
4. If the test continues to fail, escalate the problem.
PASS The system and the Maintenance/Test analog port agree on the
Maintenance/Test analog port hook state.
Packet Bus Port Health Inquiry Test (#567)
This test verifies that the packet bus fault-detection and maintenance function of the M/T-PKT is
functioning properly. This is done by having the M/T-PKT perform a self-test. If the self-test
passes, then the Packet Bus Port Health Inquiry test passes. If the self-test fails or
Communication Manager cot communicate with the M/T-PKT, then the test fails.
This test runs on M/T-PKT (Maintenance/Test Packet Bus Port).
Table 399: Packet Bus Port Health Inquiry Test (#567) 1 of 2
Error
Code
Test
Result
Description / Recommendation
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT System resources necessary to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2500 ABORT An internal operation failed, and the test could not be completed.
1. Retry the command at 1-minute intervals up to 5 times.
1368 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2
1 of 2