Demand test descriptions and error codes - Avaya Support

For individual port problems see the relevant MO:
● If the port is administered as a CO trunk, see CO-TRK (Analog CO Trunk).
● If the port is administered as a DID trunk, see DID-TRK (Direct Inward Dial Trunk).
● If the port is administered as a CAMA/E911 trunk, see DIOD-TRK (DIOD Trunk).
● If the port is administered as an analog line, see AN-LN-PT (Analog Line Port).
● If the port is administered as an external device alarm, see ALARM-PT (Alarm Port).
● If the port is administered as an analog endpoint, see ANL-LINE (8-Port Analog Line).
Error log entries and recommended actions
Table 186: MG-IAMM Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
1 (a) 0 Sanity Failure MIN ON
Recommended Action
18 (b) 0 busyout location OFF release location
23 (c) WRN OFF
257 (d) 65535 Control Channel
Looparound Test
513 (e) Any MIN ON
769 (f) 4358
MIN ON test board location r 20
Notes:
a. Error Type 1: the Integrated Analog Media Module (IAMM) has stopped functioning or was
physically removed from the system. This alarm is logged 11 minutes after removing the
media module or the SAKI Sanity Test fails. NOTE: The IAMM is not removable. This error
indicates that there may be a firmware or hardware problem with the media gateway.
1. Reset the Integrated Analog Media Module with reset board .
2. Retest the board using test board location.
3. If this error persists, replace the media gateway.
b. Error Type 18: the indicated Integrated Analog Media Module circuit has been made
unavailable with the busyout location command. To resolve this error, enter
release location for the alarmed media module.
646 Maintenance Alarms for Communication Manager, Media Gateways and Servers