Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 538: Verify NIC Options Test (#1511) 1 of 3
Error
Code
Test
Result
Description / Recommendation
1014 ABORT Board is not inserted.
1. Enter list configuration board to ensure that the circuit pack
is inserted in the carrier.
2. If the board is not inserted, make sure the circuit pack is inserted in
the carrier and fully seated.
1022 ABORT Invalid board. The board is not capable of changing its Ethernet options.
1115 ABORT Unable to allocate system resources to run this test.
1. Retry the test at one minute intervals up to a maximum of 3 times.
2000 ABORT Response to the test was not received within the time allowed. Retry the
command at 1 minute intervals a maximum of 3 times.
1. If this result occurs repeatedly, attempt to reset the circuit pack.
2. Rerun the test. If this result occurs again after resetting the board,
replace the circuit pack.
2012
2100
2500
ABORT Internal system error.
System resources required for this test are not available.
Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2801 ABORT Could not find the IP address for this board.
1. Enter change ip-interfaces location to administer an IP
address for this board.
2. Rerun the test.
2807 ABORT The board is administered but not enabled on the ip-interfaces form.
1. Enter change ip-interfaces location to enable the board.
2. Rerun the test.
1680 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 3