Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 432: Standby Reference Health Check Test (#651)
Error
Code
0
1
Test
Result
FAIL
FAIL
Description / Recommendation
Tie Trunk Dial Test (#747)
The external synchronization timing source for side A of the Stratum-3
clock or for the primary DS1 reference is either absent or invalid. The
external synchronization timing source for side B of the Stratum-3 clock or
the secondary DS1 reference is not yet tested.
The external synchronization timing source for side B of the Stratum-3
clock or for the secondary DS1 reference is either absent or invalid.
1. Correct the synchronization source problem. See SYNC (Port
Network Synchronization).
2. If the error still exists, replace the IPSI or Tone-Clock circuit pack
reported in the error log. See Replacing the IPSI or Tone-Clock
Circuit Pack.
PASS The external synchronization timing source is valid.
This test performs a dial tone/seizure test on a 2W LD tie trunk port. It seizes a trunk and
outpulses a pause digit. It aborts on ports administered as access endpoints.
This test runs on TIE-TRK (Analog Tie Trunk).
Table 433: Tie Trunk Seizure Test (#747) 1 of 3
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1442 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 3