Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 295: Tone Generator Transmission Test (#40) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT The system was not able to allocate all the resources needed for this
test or there was an Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1 ABORT The system could not allocate all the resources needed to test the
DTMF tones.
1. Retry the command at 1-minute intervals up to 5 times.
1001 ABORT The system was not able to put the tone generation facility in the
appropriate mode to test it.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test connection. This
can happen when the system is heavily loaded.
1. If the system is not heavily loaded, test the TDM bus with
test tdm port-network P.
2. Retry the command at 1-minute intervals up to 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see
information regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1022 ABORT Tone detection for the system is administered as wide broadband (tone
detection mode 5), and the Tone Detector used for this test was not a
TN420C (the only circuit pack with this capability). GPTD ports on other
types of Tone Detector circuit packs are taken out of service since they
cot provide the administered function. Either:
● Change the tone-detection mode administered on the
system-parameters country-options screen.
● Remove all non-TN420C circuit packs from the system.
1412 ABORT This test does not run on media modules or media gateways. Ignore
1136 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2