Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 414: BRI Port Local TDM Looparound Test (#619) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1000 ABORT The system resources required to run this test are not available. The port
may be busy with a valid call.
1. Enter display port location to determine the station
extension or trunk group/member number of the port.
2. Enter status bri-port location to determine the service
state of the port. If the port is in use, wait until the port is idle before
retesting.
3. Retry the command at 1-minute intervals up to 5 times.
4. If the test continues to abort, escalate the problem.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service
due to TDM-BUS errors. A system is considered under heavy traffic
when the Call Processing Occupancy is greater than 50% or when the
System Management and the Call Processing Occupancies together
exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1400 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2