Demand test descriptions and error codes - Avaya Support

MG-IAMM (Integrated Analog Media Module)
MG-IAMM (Integrated Analog Media Module)
MO Name in Log Alarm Level Initial Command to Run Full Name of MO
MG-IAMM MIN test board location long Integrated Analog
Media Module
The MG-IAMM Maintenance Object resides on the Integrated Analog Media Module (IAMM)
which is located on the main board of the G250, G250-BRI, G250-DCP, G250-DS1, G350, and
TGM550 media gateways.
The Integrated Analog Media Module is not field-replaceable.
For the G250, the Integrated Analog Media Module consists of six (6) fixed configuration analog
ports:
● Ports 1 through 4 are fixed as loop start CO trunk ports.
● Ports 5 and 6 may be administered as analog stations, DID trunks, or external alarm ports.
● Ports 4 and 5 are used by the media gateway processor for emergency transfer relay
(ETR) purposes.
The Integrated Analog Media Module is a non-field-replaceable module. Slot #3 is virtual and
designated as the integrated analog media module slot. Slot #3 supports the IAMM exclusively.
For the G250-BRI and G350, the Integrated Analog Media Module consists of three (3) fixed
configuration analog ports:
● Port 1 is fixed as an analog trunk port.
WRN test board location
● Ports 2 and 3 are fixed as analog line ports.
● Ports 1 and 2 are used by the media gateway processor for emergency transfer relay
(ETR) purposes.
On a G250-BRI, slot #3 is virtual and designated as the integrated analog media module slot.
On a G350, slot #7 is virtual and designated as the integrated analog media module slot.
Administration will only allow port one to be administered as a loop start CO trunk. Ports 2 and 3
may only be administered as analog stations, DID trunks, or external alarm ports. Ports 1 and 2
are used by the emergency transfer relay (ETR).
The TGM550 is the Media Gateway blade which is integrated with the Juniper Networks
Services Routers. It provides an internal interface to the Juniper chassis backplane, 2 analog
lines, and 2 analog trunks. Ports 2 and 3 are used by the emergency transfer relay (ETR).
The G250-DCP allows 4 trunks and 2 analog lines. Ports 4 and 5 are used by the ETR.
The G250-DS1 allows 1 trunk and 2 analog lines. Ports 1 and 2 are used by the ETR.
See XXX-BD (Common Port Circuit Pack/Media Module) for media module level errors.
Issue 5 May 2009 645