Demand test descriptions and error codes - Avaya Support

Table 504: TCP/IP Ping Test (#1281) 2 of 3
Error
Code
Test
Result
Description / Recommendation
TCP/IP Ping Test (#1281)
10 ABORT No response to the ping, and the C-LAN is locked up in the ping task.
1. Reset the C-LAN circuit pack and retest.
2. If the test fails again, replace the C-LAN circuit pack.
11 ABORT Internal error
1. Retry the command at 1-minute intervals up to 3 times.
1005 ABORT Test configuration is incorrect.
1. Verify that the link is in service with status port location
or status link n.
2. Repeat the test.
1124 ABORT PPP/Ethernet link is not enabled.
1. Verify that the PPP/Ethernet link is enabled with
status port location, status link n, or
display data-module.
2. If the link is not enabled, enable the link using
change data-module
3. Repeat the test.
1125 ABORT PPP/Ethernet link not in service.
1. Verify whether the PPP/Ethernet link is in service with
status port location or status link n.
2. If the link is not in service, release the link with
release link n or release port location.
3. Repeat the test.
2000 ABORT Response to the test was not received within the allowed time.
1. Attempt to reset the circuit pack if the other ports on the board are
idle (amber LED is off).
2. If the test fails again, replace the circuit pack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2 of 3
Issue 5 May 2009 1623