Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 284: Battery and Power Supply Query Test (#5) 4 of 7
Error
Code
Test
Result
Description / Recommendation
4 FAIL DC-powered cabinet: The PN’s Maintenance circuit pack is
incorrectly reporting a problem with power. Replace the suspect circuit
pack and run the test again.
AC-powered cabinet: The battery is currently being charged.
1. After 30 hours, the battery should be fully charged, and this error
should clear.
2. If after 30 hours the battery is still in the high charge rate, an
alarm will be raised. Enter display errors to display the Error
Log, and select the category “environs” to show only
environment-related errors. Look for POWER errors of type 257.
The first occurrence of this error indicates the time when the
battery started charging. Use this time as the starting point to
determine whether the battery has been charging for 30 hours. If
so, replace the battery and battery charger.
CAUTION: Read
! CAUTION:
the section, Replacing the Battery and Battery
Charger (J58890CE) before proceeding.
3. Rerun the test. If the test still fails, the PN’s MAINT (Maintenance)
circuit pack could be reporting this condition incorrectly. There are
failures that can occur on the PN’s Maintenance circuit pack that
will not be detected by their respective maintenance, but which
will cause many, if not every, environment test to fail. If many
environment tests are failing, the suspect circuit pack, depending
on the system configuration, should be replaced and the test
rerun. Resolve every alarm on these MOs, and rerun the test.
6 FAIL DC-powered cabinet: The PN’s Maintenance circuit pack is
incorrectly reporting a problem with power. Replace the suspect circuit
pack and run the test again.
AC-powered cabinet: This indicates that Error Codes 2 and 4
occurred. Refer to these descriptions. Also, refer to this test’s
description for Error Code 14.
1080 Maintenance Alarms for Communication Manager, Media Gateways and Servers
4 of 7