Demand test descriptions and error codes - Avaya Support

Table 287: GPP NPE Crosstalk Test (#9) 5 of 6
Error
Code
1004
(cont’d)
Test
Result
Description / Recommendation
GPP NPE Crosstalk Test (#9)
PDMODULE and TDMODULE:
1. Enter display port location to determine the extension of
the data module port.
2. Enter status data-module extension to determine the
service state of the port. If the port is in use, wait until it is idle
before testing.
3. Retry the command at 1-minute intervals up to 5 times.
1020 ABORT The test did not run due to a previously existing error on the specific port
or there is a more general circuit pack error.
1. Enter display errors and check the Error Log for existing
errors against this port or circuit pack. Attempt to diagnose the
previously existing error.
2. After resolving the previously existing errors, retry the command.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
2000 ABORT Response from the test was not received within the time allowed.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
5 of 6
Issue 5 May 2009 1103