Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Speech Synthesis PSS Handshake Test (#168)
This test verifies control functionality between the on-board microprocessor and programmable
speech synthesizer (PSS) controller. A failure occurs if either of the following events occur:
● The on-board microprocessor times out while waiting for the PSS controller to respond.
● An invalid command is received by the on-board microprocessor from the PSS controller.
This type of failure will affect all four ports on the Speech Synthesis circuit pack, resulting in
errors or alarms on each port. This test runs on S-SYN-PT (Speech Synthesis Port).
Table 356: Speech Synthesis PSS Handshake Test (#168)
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port
may be busy with a valid call.
1. Wait until the port is idle (amber LED is off), then retry the
command at 1-minute intervals up to 5 times.
2000
2100
ABORT Response to the test was not received within the allowed time.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The on-board microprocessor has timed out while waiting for the PSS
controller to respond or an invalid command has been received by the
on-board microprocessor from the PSS controller. This type of failure
may cause features using the Speech Synthesis port’s speech services
to malfunction.
1. Replace the circuit pack.
PASS The on-board microprocessor/PSS handshake is working correctly.
Investigate user-reported troubles by using other tests and by verifying
other ports on this circuit pack are working correctly.
1274 Maintenance Alarms for Communication Manager, Media Gateways and Servers