Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Angel Speech Processor Handshake Test (#208)
This test checks the integrity of the communication link between the two processors on the
announcement circuit pack. This test runs on -BD (Announcement circuit pack).
WARNING: Failure
of this test indicates that the Speech Processor is insane and results in
the loss of all integrated announcements on the circuit pack.
Table 362: Angel Speech Processor Handshake Test (#208)
Error
Code
Test
Result
Description/ Recommendation
2000 ABORT Response to the test request was not received within the time allowed.
1. Check the Error Log with display errors. If Error Type 1538 is
present in the Error Log, reset the circuit pack.
2. Retry the test at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL The test failed. The circuit pack cot be used. announcement speech
memory is cleared when this test fails. Therefore, when the problem has
been resolved, announcements must be rerecorded or downloaded to
the circuit pack.
1. Reset the circuit pack via reset board location and then run
this test again. If the test continues to fail, replace the circuit pack
and run this test again.
2. If there are recurring alarms on this circuit pack caused by this test
failing, replace the circuit pack even if Step 1 works.
WARNING: Replacing
the circuit pack results in loss of integrated
announcements. See General notes.
PASS The communications link between the two processors on the
announcement circuit pack is functioning properly. Investigate
user-reported troubles on this circuit pack using other circuit pack and
port tests. Refer to -PT (Announcement Port) for a description of the tests.
1288 Maintenance Alarms for Communication Manager, Media Gateways and Servers