Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 517: IP Address Update Test (#1371) 2 of 2
Error
Code
Test
Result
Description / Recommendation
6 FAIL The packet link for the board is not up.
1. Check the state of the packet bus for the port network.
2. If the packet bus is OK, attempt to re-initialize the board by entering
the following commands:
- disable ip-interface
- reset board location
- release board location
3.
- enable ip-interface.
If the problem persists, replace the circuit pack.
2807 FAIL The board is administered, but not enabled on the change
ip-interfaces form. The board and its DSPs are taken out of service.
1. Enable the board on the change ip-interfaces form.
2. Rerun the test.
3. If the problem continues, replace the circuit pack.
PASS Translation data matches.
4 PASS Duplicate IP address detected. Circuit pack administration contains an IP
address that is a duplicate of an existing network IP address. This could
cause problems in the network and problems with calls on the circuit pack.
Registration Status Inquiry Test (#1372)
The Registration status inquiry reports the H.323 registration status of the endpoint. An endpoint
must be registered and authenticated in order to receive service from the system.
Registration is initiated when the endpoint user attempts to login using the Avaya registration
software application running on the endpoint PC. The user must provide a valid extension and
security code. The registration messages are sent to the IP address of a C-LAN Ethernet port.
A registered extension has a port type of SNNNNN, where N is a digit from 0–9. A
non-registered extension has a port type of X.
This test runs on DIG-IP-S (Digital IP Station) and H323-STN (H.323 IP Station).
1648 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2