Demand test descriptions and error codes - Avaya Support

Table 438: FIBER-LK Configuration Audit (#759) 4 of 10
Error
Code
Test
Result
Description / Recommendation
Configuration Audit (#759)
133 FAIL No neighbor link is assigned, but the SNI has an EI neighbor.
1. Enter list fiber-link to see a fiber link’s endpoints.
2. Administer the SNI on a fiber link to the EI neighbor it is connected to
via add fiber-link next. Or remove both fiber endpoints (i.e.,
this SNI and its EI neighbor) and remove the fiber endpoints from
circuit pack administration via change circuit-pack.
134 FAIL No neighbor link is assigned, but the SNI has an SNI neighbor.
1. Enter list fiber-link to see a fiber link’s endpoints.
2. Administer the SNI on a fiber link to the SNI neighbor it is connected
to via add fiber-link next. Or remove both fiber endpoints (i.e.,
this SNI and its SNI neighbor) and remove the fiber endpoints from
circuit pack administration via change circuit-pack.
135 FAIL The SNI circuit pack cot communicate with its assigned neighbor.
1. Enter list fiber-link to see a fiber link’s endpoints.
2. Check if the administered neighbor is inserted. If not, insert the
neighbor circuit pack.
3. Perform the Fiber link fault isolation in Chapter 4: General
troubleshooting in Maintenance Procedures for Avaya Aura
Communication Manager, Media Gateways and Servers
(03-300432).
136 FAIL The Endpoint 1 SNI’s administered neighbor does not match the physical
neighbor connected.
1. Enter list fiber-link to see a fiber link’s endpoints. The SNI’s
assigned neighbor is another SNI, but the SNI is physically
connected to an EI.
2. Enter list fiber-link and verify that the fiber-optic and metallic
cables are installed as administered.
4 of 10
Issue 5 May 2009 1463