Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 538: Verify NIC Options Test (#1511) 3 of 3
Error
Code
Test
Result
Description / Recommendation
2 FAIL The board is reporting different options than what is administered.
Software tried to correct the options but the board did not accept the
option update.
1. Set the administration values to the actual values that the board is
reporting. The commands to change administration are:
f. Enter get ethernet-options location to determine
the current settings, both administered and actual.
g. Enter change ip-interface location and change the
Enable Ethernet Port field to n to turn off the interface.
Submit the form to disable the interface.
h. Enter change ip-interface location and change
the Ethernet Options fields as required. Submit the form.
i. Enter change ip-interface location and change the
Enable Ethernet Port field to y to turn on the interface.
Submit the form to enable the interface.
j. Enter get ethernet-options location to verify that
Ethernet options are the same in administration and on the
board.
2. Test the board using the test board location command. If the
test still fails, replace the board.
3. If service is normal and the alarm is causing concern, disable the test
and escalate the problem.
PASS The circuit pack’s network interface parameters match administration.
Link State Audit Test (#1527)
This test verifies the Media Gateway H.248 link state and alarm state. If the user knows the MG
is up but there is still an alarm indicating the link is down, this test should be run by using
test media-gateway location.
This test runs on MED-GTWY (MEDIA GATEWAY).
1682 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 3