Demand test descriptions and error codes - Avaya Support

Table 40: Error codes and Aux Data values ATM-NTWK 2 of 6
Cause
Code/
Error
Type
Aux
Data
ATM-NTWK (ATM Network Error)
21 (a) Call rejected. This cause indicates that the equipment sending this cause
does not wish to accept this call, although it could have accepted the call
because the equipment sending this cause is neither busy nor
incompatible.
Note: If the call was rejected by the far-end ATM-EI or ATM-CES board,
there could also be additional information about this rejection in an ATM-EI
error log entry. Look for an ATM-EI or error with an Error Type between
1104 and 1119 inclusive, with approximately the same time stamp as this
error.
22 (a) Number changed. This cause is returned to a calling party when the called
party’s number indicated by the calling user is no longer assigned. The new
called party’s number can optionally be included in the diagnostic field. If a
network does not support this capability, cause number 1 “unassigned
(unallocated) number” is used.
23 (a) User rejects every call with CLIR (calling line identification restriction). This
cause is returned by the called party when the call is offered without calling
party’s number information and the called party requires this information.
27 (a) Destination out of order. This cause indicates that a user-indicated
destination cot be reached because a signaling message could not be
delivered to the remote user over the destination’s interface (for example, a
physical-layer or SAAL failure at the remote user, or remote user’s
equipment is off line).
28 (a) Invalid number format (address incomplete). This cause indicates that the
called user cot be reached because the called party’s number is not in a
valid format or has insufficient digits.
30 (a) Response to STATUS ENQUIRY. This cause is included in the STATUS
message when the reason for generating the STATUS message was the
prior receipt of a STATUS ENQUIRY message.
31 (a) Normal, unspecified. When no more specific cause values apply, this cause
reports a normal event.
32 (a) DTL transit not-my-node ID
RESOURCE UNAVAILABLE
Cause Codes Description
35 (a) Requested VPCI/VCI not available. This cause indicates that the requested
VPCI/VCI is not available. This can be caused by mismatched VCI ranges
on different ATM switches.
36 (a) VPCI/VCI assignment failure
2 of 6
Issue 5 May 2009 149