Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 293: Port Diagnostic Test (#35) 4 of 6
Error
Code
Test
Result
Description / Recommendation
1392 ABORT This port is a TTI port. The test will not run on TTI ports.
1. Verify that the port is a TTI port using either display port,
which shows that the port is a TTI port, or list config, which
shows a t for the port.
2. If either command indicates that the port is a TTI port, the abort is
correct for the test and no action is necessary.
3. If the port is not a TTI port, escalate the problem.
2000 ABORT Response from the test was not received within the time allowed.
1. Retry the command at 1-minute intervals up to 5 times.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100 Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
61446 FAIL DID-TRK: Battery feed test failed. A loop current fault was detected.
This is most likely an incoming CO-line problem.
1. Check the incoming CO-line for loop current. If none is detected
refer the problem to the CO.
2. If the CO-line checks out OK, the failure must be on the DID port.
Replace the circuit pack.
61456 FAIL DID-TRK: Battery feed test failed. An on-board problem was detected.
This port is out-of-service.
1. Replace the circuit pack or media module.
61472 FAIL DID-TRK: Battery feed test failed. A problem with the incoming CO-line
was detected.
1. Check the incoming CO-line for proper operation. If warranted,
refer the problem to the CO.
2. If the CO-line is not at fault, the failure must be on the DID port.
Replace the circuit pack or media module.
1128 Maintenance Alarms for Communication Manager, Media Gateways and Servers
4 of 6