Demand test descriptions and error codes - Avaya Support

Table 320: Modem Pool Conference Test (#97) 2 of 4
Error
Code
Test
Result
Description / Recommendation
Modem Pool Conference Test (#97)
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port has been seized by a user for a valid call. Determine whether
the port is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
1020 ABORT The test did not run due to a previously existing error on the specific port
or because of a more general circuit pack error.
1. Check the Error Log for existing errors against this port or the circuit
pack, and attempt to diagnose existing errors.
2000 ABORT The response to the test was not received in the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2012 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2103 ABORT The system could not make the conference connection for the test.
1. Retry the command at 1-minute intervals up to 5 times.
2 of 4
Issue 5 May 2009 1193