Demand test descriptions and error codes - Avaya Support

AC Power Query Test (#78)
AC Power Query Test (#78)
The AC Power Query Test queries either the server’s watchdog via an Ethernet or USB
interface or an MCC PN’s Maintenance circuit pack for the status of the cabinet’s AC power.
The AC Power Query Test (#78) is not valid for DC-powered cabinets and should either abort or
pass.
This test runs on the following maintenance objects:
● AC-POWER
● CABINET (Cabinet Sensors)
● CARR-POW (Carrier Power Supply)
● EMG-XFER (Emergency Transfer)
● POWER
Table 316: AC Power Query Test (#78) 1 of 3
Error Code Test
Result
Description / Recommendation
1000 ABORT System resources required to run test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response from the test was not received within the time allowed.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to ABORT with Error Code 2000, check
for system powering problems with the PN’s A carrier.
Resolve every AC-POWER, CARR-POW, and RMC-ENV
alarm. Repeat the test.
3. If the test still ABORTs with Error Code 2000, check for and
resolve every MAINT (Maintenance circuit pack) error in a PN.
Repeat the test.
4. If the test still ABORTs with Error Code 2000, escalate the
problem.
2028
2319
2320
2500
ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1 of 3
Issue 5 May 2009 1183