Demand test descriptions and error codes - Avaya Support

Modem Pool Audit Test (#99)
Modem Pool Audit Test (#99)
This audit updates the Modem Pool conversion resource status contained in the TN758 Pooled
Modem circuit pack’s microprocessor. It does not test the Pooled Modem circuit pack, so there
are no FAIL codes. The audit can only be performed on idle conversion resources. If the
conversion resource is in use, the audit aborts.
This test runs on MODEM-PT (Modem Pool Port).
Table 322: Modem Pool Audit Test (#99)
Error
Code
Test
Result
Description / Recommendation
Any ABORT The system was not able to allocate all necessary resources to run this
test. The conversion resource was in use when the audit was performed.
No repair action is necessary unless the conversion resource was known
to be idle during the test (amber in-use LED was off) or was busied out
before the test was run. In that case, a TN758 failure condition may exist
and the following steps should be used:
1. Busyout both of the TN758 Pooled Modem conversion resources on
the circuit pack containing the failing conversion resource.
2. If the test continues to abort, replace the Pooled Modem circuit pack
and retest.
PASS The audit passed.
Issue 5 May 2009 1201