19.12.2012 Views

Demand test descriptions and error codes - Avaya Support

Demand test descriptions and error codes - Avaya Support

Demand test descriptions and error codes - Avaya Support

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Table 330: Cabinet Temperature Query Test (#122) 4 of 6<br />

Error<br />

Code<br />

Test<br />

Result<br />

1 FAIL<br />

(cont’d)<br />

Description / Recommendation<br />

Cabinet Temperature Query Test (#122)<br />

NONVARIABLE-SPEEDFAN ASSEMBLIES in older or upgraded<br />

cabinets: The AHD1 circuit pack has reported an air-flow problem. The<br />

temperature difference between the air intake <strong>and</strong> the air exhaust is at<br />

least 15 0 C (59 0 F)) <strong>and</strong> the absolute temperature at the top of the cabinet<br />

is at least 500C (1220F). The fans should be running at high speed. If<br />

none of the fans are running:<br />

1. Look for an resolve every alarm against CARR-POW (Carrier Power<br />

Supply).<br />

S8700-series IP-PNC Look for an resolve every alarm against<br />

RMC-ENV (Power/Fan Sensors).<br />

2. Verify that 48 VDC is available to the fan wiring harness connector<br />

between pin pairs 2/3, 8/9, <strong>and</strong> 10/11. The tolerable range for this<br />

measurement is -42.5 V to -52.5 V.<br />

If 48 VDC is present <strong>and</strong> the fans are not running, replace the AHD1<br />

circuit pack. If the fans still do not run, escalate the problem.<br />

3. If 48 VDC is absent, replace the CFY1B current limiter card.<br />

If the fans still do not run, escalate the problem.<br />

If some fans are running <strong>and</strong> some not, replace the defective fans.<br />

4. If every fan can be started, wait 5 minutes <strong>and</strong> rerun the <strong>test</strong>. If the<br />

<strong>test</strong> fails again, proceed to the next step.<br />

5. If every fan is running but not at high speed, measure the cabinet<br />

temperature at the air intake <strong>and</strong> the air exhaust at the top of the<br />

cabinet.<br />

a. If the 150- /500-C criteria is met, there is a problem with the<br />

AHD1 circuit pack or the fans. Replace the AHD1 circuit pack<br />

<strong>and</strong>/or fans. If the fans run at high speed, wait 5 minutes for the<br />

cabinet to cool, then re<strong>test</strong>. If the <strong>test</strong> fails, escalate the<br />

problem.<br />

b. If the 15 0- /50 0- C criteria is not met, environmental maintenance<br />

is incorrectly reporting this condition. Resolve every <strong>error</strong><br />

(S8700-series Fiber-PNC: MAINT (PN Maintenance Circuit Pack))<br />

<strong>and</strong> re<strong>test</strong>. If the <strong>test</strong> fails, escalate the problem.<br />

4 of 6<br />

Issue 5 May 2009 1219

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!