Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 282: Dial Tone Test (#0) 2 of 4
Error
Code
Test
Result
Description / Recommendation
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service
due to TDM-BUS errors. A system is considered under heavy traffic
when the Call Processing Occupancy is greater than 50% or when the
System Management and the Call Processing Occupancies together
exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port was seized by a user for a valid call.
1. Enter display port location to determine the trunk group/
member number of the port.
2. Enter status trunk to determine the service state of the port. If
the service state indicates that the port is in use, wait until the port
is idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT Trunk has been administered as incoming-only or DID trunk group type.
Dial tone can only be obtained on outgoing trunks. This is a normal
condition.
1018 ABORT Test has been disabled by administration. Determine why this test was
disabled before enabling it.
1. To enable the test, enter change trunk-group . Enter y
in the Maintenance Tests field, and submit the screen.
2. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response from the test was not received within the time allowed.
1. Retry the command at 1-minute intervals up to 5 times.
1072 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 4