Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 562: Power Supply Aux Sig Test (#1649) 2 of 2
Error
Code
Test
Result
PASS The power supply detection test passes.
NO
BOARD
Description and recommendation
Power supply is administered but not detected.
1. Verify that the power supply is plugged in.
2. Replace the power supply.
Board Health Query Test (#1652)
This test checks the state of health of the TN2602 circuit pack. It runs on IPMEDPRO
(TN2602AP IP Media Resource 320).
Table 563: Board Health Query Test (#1652) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1720 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2
1005 ABORT Test not applicable to this board. The firmware is too old to run this test.
2000
2012
2100
2500
Response to the test was not received within the allowed time.
Internal system error.
Could not allocate the necessary system resources to run this test.
Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2801 ABORT Unable to find IP address data for this location.
1. Verify that the board is administered.
2807 ABORT The board is administered but not enabled on the
change ip-interfaces form.
1. Enable the board on the change ip-interfaces form. Rerun
the test.
2. If the problem continues, replace the circuit pack.
1 of 2