Demand test descriptions and error codes - Avaya Support

Stand-Alone DCP Data Modules
PDMODULE (Processor Data Module)
There are two types of stand-alone DCP data modules as shown in Table 201.
Table 201: Stand-Alone DCP Data Modules
Type Name 1
Data Adapters
TN2136 circuit packs use IDCP signaling and a DAA2 Data Adaptor (DA) to interface to DTE.
DAs can operate in either of two modes which are covered by different MOs:
Configurations and Maintenance
Interfaces to:
MPDM Modular Processor Data Module DTE (data terminals, host computers,
printers, etc.)
MTDM Modular Trunk Data Module DCE (modems, data modules, etc.)
1. Early versions of these data modules were referred to as PDMs and TDMs, respectively. Later models
are designed to provide a variety of interfaces by using interchangeable modules and are thus called
modular data modules.
Table 202: Data Adaptor Modes
DA Mode Administered as: Endpoint Maintenance
Object
Stand-Alone PDM data endpoint only PDMODULE
Linked DTDM IDT1/2 1 and optional data terminal
DIG-LINE
1. IDT1/2: Italtel Digital Telephone, Model 1 or 2 (also known as Digital Telephones TD7210 and
TD7206).
The MPDM provides an interface for Data Terminal Equipment (terminals), and the MTDM (see
Note) provides an interface for Data Communications Equipment (transmission equipment such
as modems).
Issue 5 May 2009 699