Demand test descriptions and error codes - Avaya Support

This test runs on POW-SUP (Power Supply).
Table 562: Power Supply Aux Sig Test (#1649) 1 of 2
Error
Code
Test
Result
Description and recommendation
Power Supply Aux Signal Test (#1649)
1000 ABORT Internal software error.
1. Retry the command.
2. Escalate the problem if the test continues to abort.
1035 ABORT The port network is not available.
1. Enter status port-network to verify that the network is
down.
2. Look for alarms against EXP-PN (Expansion Port Network),
EXP-INTF (Expansion Interface Circuit Pack), PKT-INT (Packet
Interface), etc.
3. Use diagnostic procedures for those MOs to clear the problem.
1987 ABORT The power supply data was not valid.
1. Repeat the command at one-minute intervals 1 to 3 times.
2000 ABORT The response to the test was not received in the time allowed.
1. Repeat the command at one-minute intervals 1 to 3 times.
2029 ABORT There is a problem communicating with the environmental
maintenance firmware.
1. Run test maintenance nn
2319 ABORT The EPN is out of range.
2500 ABORT An internal operation failed
1. Retry the command.
2. Escalate the problem if the test continues to abort.
1 FAIL Failure detected at the power supply and the IPSI
1. Replace the power supply.
2 FAIL Failure detected at the power supply but not the IPSI
1. Replace the power supply.
1 of 2
Issue 5 May 2009 1719