Demand test descriptions and error codes - Avaya Support

f. Error Type 515: For the TN802B only, this Error Type indicates that every DSP is OOS (out
of service), and a MINOR alarm is raised. The Aux Data field contains the number of DSPs
that are OOS.
g. Error Type 770: DSP overallocation error. Since this error causes the DSP audit to run, the
condition is cleared and no action is necessary. This error is logged only. No alarms are
generated.
h. Error Type 1025: The port is OOS (out of service) because of a board-level failure. Check
for errors/alarms against the board, in particular ping problems, IP address inconsistency, or
board sanity problems.
1. Verify correct administration.
2. Check cabling and customer network before replacing circuit pack.
Demand test descriptions and error codes
Investigate tests in the order presented. By clearing errors associated with the first test, errors
generated from other tests may also be cleared. Click on the link to see the full description of
the test, error codes, and recommended actions.
Order of Investigation Short Test
Sequence
1. D = Destructive; ND = Nondestructive
Long Test
Sequence
618 Maintenance Alarms for Communication Manager, Media Gateways and Servers
D/ND 1
DSP Query Test (#1382) X X ND
DSP Port TDM Looparound Test (#1380) X X ND
DSP Port Status Query Test (#1407) X X ND